ABB Feather Duster V2 Product Manual page 64

3 Installation and commissioning
3.3.3 Installing the Feather Duster V2
Continued
3
4
5
Continues on next page
64
Action
Insert the locating pin to locate the steel
structure frame
Tighten all the screws.
Fit the exhaust pipe covers and secure them
to the convert adaptors with screws and
washers.
CAUTION
When fitting the exhaust pipe covers, make
sure the inner edge of the covers must press
on the lip of the V-ring on the axis 6.
xx1800001345
© Copyright 2018 ABB. All rights reserved.
Note
xx1800001343
Screw: M12x25 (11 pcs)
Tightening torque: 145 Nm
xx1800001344
xx1800001346
Screw: M8x20 (4 pcs)
Tightening torque: 43 Nm
Product manual - Feather Duster V2
3HAX010000210 Revision: A