ABB Feather Duster V2 Product Manual page 140

5 Repair
5.2.4 Replacing the bearing housing
Continued
4
Refitting the feather roller
1
2
Continues on next page
140
Action
Tighten the screw above the motor to fix
the adjustable plate.
Action
Put the feather roller back on to the frame.
Note
The roller has a boss at one end. The boss
must be aligned with the key slot on the
support shaft. This ensures the correct in-
stallation of the feather roller.
Insert one side of the feather roller, and
rotate it to make the plate for spring out
from the groove of the connected shaft.
© Copyright 2018 ABB. All rights reserved.
Note
Screws: M5x25 (1 pcs)
Tightening torque: 5 Nm
xx1800001767
Note
xx1800001555
Product manual - Feather Duster V2
3HAX010000210 Revision: A