ABB Feather Duster V2 Product Manual page 101

Refitting the feather roller
Use these procedures to refit the feather roller.
Refitting the feather roller
1
2
3
4
Product manual - Feather Duster V2
3HAX010000210 Revision: A
Action
Put the feather roller back on to the frame.
Note
The roller has a boss at one end. The boss
must be aligned with the key slot on the
support shaft. This ensures the correct in-
stallation of the feather roller.
Insert one side of the feather roller, and
rotate it to make the plate for spring out
from the groove of the connected shaft.
Refit the other side of the feather roller in
the suitable position.
Insert the setting screw into the correct
position.
© Copyright 2018 ABB. All rights reserved.
5.2.1 Replacing the feather roller
Note
xx1800001555
xx1800001554
xx1800001553
Continues on next page
5 Repair
Continued
101