ABB Feather Duster V2 Product Manual page 70

3 Installation and commissioning
3.3.4 Connecting exhaust hose and cables
Continued
2
3
4
5
6
Continues on next page
70
Action
Separate the two halves of the hose holder by
pulling them sidewards and then turning a little in
different directions.
Put the exhaust hose to the hose holder.
Close the hose holder and tighten the screws.
Repeat the previous steps until the exhaust hose
is routed through all the hose holders.
CAUTION
The exhaust hose sections between every two
hose holders must not be straightened. When the
robot axis turns or bents, the exhaust hose must
be flexible to move together.
Secure the exhaust hose to the exhaust hose
connector with an adjustable hoop.
© Copyright 2018 ABB. All rights reserved.
Note
xx1800001541
xx1800001542
xx1800001543
xx1800001544
Product manual - Feather Duster V2
3HAX010000210 Revision: A