ABB Feather Duster V2 Product Manual page 129

3
4
5
Product manual - Feather Duster V2
3HAX010000210 Revision: A
Action
Rotate the feather roller manually, and
make the plate for spring insert into the
groove, until it collide a location pin in the
connected shaft.
Uplift the feather roller a little to remove it.
CAUTION
Pay attention not to collide with the ionizing
air knife or safety edge sensor.
Put the feather roller on the feather roller
support.
© Copyright 2018 ABB. All rights reserved.
5.2.4 Replacing the bearing housing
Note
xx1800001766
xx1800001555
xx1800001556
xx1600000734
Continues on next page
5 Repair
Continued
129