Table of Contents
Advertisement
184/261
Bosch Rexroth AG | Electric Drives
Connection Techniques
8.2.2
Connect the Stators with Connection Cable
and Controls
Fig.8-1:
Connection scheme IndraDyn T
The electric connection of the stators is done via
●
a 2m long connection cable with wire end ferrules.
Stator with the type code option "Other design ... D30x" are delivered with
●
2m long separate wires with wire end ferrules.
●
1.5m long wires for MST210 in design "... D301".
The cable is conducted on either side of the stator, i.e. the side with the big‐
gerouter diameter or the side with the smaller outer diameter.
The following overview gives the technical data of the connection cables for
every single motor size.
Fig.8-2:
Connection cable on the stator
Rexroth IndraDyn T | Project Planning Manual
Advertisement
Table of Contents
