Table of Contents
Advertisement
220/261
Bosch Rexroth AG | Electric Drives
Installation
11.3
Mechanical Mounting
11.3.1
General Information
WARNING
11.3.2
Preparation
and Controls
The rotor is highly magnetic! Risk of injury and crimping danger by mag‐
netic forces!
⇒ Eliminate movable metal objects or secure against movement.
⇒ Careful handling of magnetic parts.
⇒ Wear protecting clothes and use mounting implements.
The following mounting instruction describes a noncommittal, schematical con‐
struction without considering the constructive speciality of the machine and
serves only for general orientation.
The machine manufacturer has to consider the special character of his con‐
struction and must work out a special mounting instruction. Only the mounting
instruction of the machine manufacturer is binding.
●
All screwed connections must be secured with screw fastener
LOCTITE 243. LOCTITE 243 - without activator and at room
temperature - is becoming hand-tight within about 15-30 mi‐
nutes. The final strength is reached after about 12 hours.
Initial state:The motor lies plane on a clean and a flat base.
1.
Check, whether the components are damaged. Defective components
must not be mounted.
2.
Hold tools, auxiliary material, measuring and test equipment ready and
make sure that the mounting can be done in a clean, dry and dust-free
environment.
3.
Check all components and mounting areas, borings and threads, as well
as the o-ring nuts on the stator whether they are clean and free of burrs.
Everything must be clean, stainless and completely free of burrs. Clean
and debur such areas if necessary.
4.
Clean before mounting the contact surface of the stators type "...ST..." with
a convenient cleanser (e.g. RIVOLTA A.C.S.3).
5.
Grease the o-rings with an ordinay lubricant grease and mount the o-rings
in the stator-nuts. Avoid twisting and polluting of the o-rings.
6.
Screw the needed ring screws in the opposite threads for transport. Check
the machine construction, whether longer ring screws with a distance tube
are required.
Attend to cleanliness at all working steps!
Heed the radial and axial forces, which arise due to the magnetic force when
introducing the rotor into the stator.
Rexroth IndraDyn T | Project Planning Manual
Advertisement
Table of Contents
