Table of Contents
Advertisement
Project Planning Manual | Rexroth IndraDyn T
7
Accessories
7.1
Mounting Ring
7.1.1
General
7.1.2
Construction
7.1.3
Ordering
To simplify the handling, transport and mounting of Rexroth IndraDyn T syn‐
chronous torque motors, a mounting fixture should be made by the machine
manufacturer according to his own specifications. This can significantly simplify
work, especially for the sizes 450 and 530. The required dimension information
is shown at the end of this chapter.
By specifying his own construction, the machine manufacturer can optimally
take into account constructional details and special work flows on his machine
during assembly, commissioning and servicing.
For sizes 450 and 530, Rexroth can provide mounting rings upon request at
additional cost. The stator and rotor are then delivered in a pre-assembled
condition if they are ordered in this manner.
●
Special constructional features of the machine or special de‐
signs cannot be taken into account in the Rexroth mounting
rings.
●
The Rexroth mounting ring is only to be used as an assembly
or application tool and must be removed before the motor is
commissioned electrically.
●
Heed the safety notes regarding handling of magnetic parts.
①
Fastening screw of the mounting ring
②
Holes for ring screws for transport (please note transport information in
section 10)
Fig.7-1:
Mounting ring for MST/MRT
The mounting rings for IndraDyn T motors are allocated according to the stator
that is used.
Electric Drives
| Bosch Rexroth AG
and Controls
175/261
Accessories
Advertisement
Table of Contents
