Bosch Rexroth IndraDyn T Project Planning Manual page 228

226/261 Bosch Rexroth AG | Electric Drives
Installation
and Controls
④
⑤
Fig.11-8: Assembly stator flange
3. Screw in the motor bearing ring (bearing ring) and rotor flange with the
fastening screws ⑧.
4. Lower the rotor flange with mounted bearing into the rotor until the cen‐
tering ⑨ on the rotor flange grips in the rotor hole.
5. Loosen the fastening screws of the assembly ring on the stator (not on the
rotor) but do not finally unscrew it.
⑥
⑦
⑧
⑨
Fig.11-9: Assembly rotor flange with bearing
6. Lower the rotor flange with assembled bearing centered over the rotor
down to its end position.
Screw the rotor flange and the rotor with the fastening screws ⑦.
7. Screw the bearing ring and stator flange with fastening screws ⑥.
Rexroth IndraDyn T | Project Planning Manual
Fastening screws for stator flange - maschine housing
Fastening screws for stator flange - stator
Bearing ring - fastening holes
Rotor flange - fastening screws
Fastening screws rotor bearing ring
Centering