Webdyn WebdynSunPM User Manual page 72

o Enter a timeout value. The default value of 2000 ms should be suitable for most
installations. For slower devices, the timeout value can be increased.
• Then click the "Start detection" button to launch the detection. The progress window
below is displayed:
On the first line, the window displays the SunSpec detection start date and time,
the interface used and an estimate of the total detection time.
The detection progress is displayed on the web page. :
o "NON SUNSPEC device found" means that a non SunSpec modbus device was
detected at the indicated modbus address:
2021-02-03 09:56:10:NON SUNSPEC device found at @1 192.93.121.23:502.
This means that a modbus device that does not meet SunSpec specifications
was found at IP address "192.93.121.23" with modbus address 1
o "SunSpec device found" means that a modbus device meeting SunSpec
specifications was detected at the indicated modbus address:
2021-02-03 09:56:21:SunSpec device found at @126 192.93.121.23:502
This means that a modbus device that meets SunSpec specifications was found
at IP address "192.93.121.23" with modbus address "126".
o "Found table" means that a SunSpec table was detected on the device. The
information line then indicates the table identifier, its size claimed by the
device as well as technical information on the device and the modbus start
register for the table:
2021-02-03 09:56:21:Found table 1:66 at 40004@126 192.93.121.23:502
Version 2.05
préliminaire
USER MANUAL – WebdynSunPM
72