Setting The Number Of Modules (Network Type) - Mitsubishi Electric Q Series Reference Manual

5 PARAMETER SETTINGS

5.1 Setting the Number of Modules (Network Type)

5 - 7
Set the network type and the station type for each module.
Up to four modules can be set for a combination of MELSECNET/H and
CC-Link IE controller network, or for Ethernet.
Note that, however, there are restrictions on the number of modules mounted for one
programmable controller CPU depending on the CPU model used. (Refer to Section
2.2.)
For the MELSECNET/H network system, select whether the station type should be the
control station, normal station or standby station.
(1) Selection type
Select from the following items:
Item
MNET/H mode (Control station)
MNET/H mode (Normal station)
MNET/10 mode (Control station)
MNET/10 mode (Normal station)
MNET/H mode Stand by station
MNET/H EX (Control station)
MNET/H EX (Normal station)
Description
Set this item for a control station of the MELSECNET/H
mode.
Set this item for a normal station of the MELSECNET/H
mode.
Set this item for a control station of the MELSECNET/10
mode.
Set this item for a normal station of the MELSECNET/10
mode.
Set this item for a standby station of a simplified redundant
system.
Set this item for a control station of the MELSECNET/H
Extended mode.
Set this item for a normal station of the MELSECNET/H
Extended mode.
MELSEC-Q
5 - 7