Mitsubishi Electric Q Series Reference Manual page 288

7 APPLICATION FUNCTIONS
: If the originating station is a Basic model QCPU (function version B or later) or Universal
Jn Target network No.
Starting I/O number of the host station network module
Un
Designate the three-digit I/O number with the first two digits.
n1 Channel used by the host
n2 Target station number
1: When the multiple CPU No. is specified for the target station CPU type (n3) and group designation (81
station number (n2), the instruction is executed for only the system where the CPU specified for the target station CPU type is the control CPU of the target
station.
Refer to Section 2.2.2 (5) for details.
7: Word device: T, C, D, W, ST, R, and ZR (The Q00JCPU cannot use R and ZR.)
7 - 86
2) Z(P).RSTOP
[Network No. designation]
Execution
command
Z.RSTOP
"Jn"
Execution
command
ZP.RSTOP
"Jn"
[Network module starting I/O number designation]
Execution
instruction
Z.RSTOP "Un" n1
Execution
instruction
ZP.RSTOP
"Un" n1
model QCPU, " "(double quotation) for the first argument can be omitted.
Description of setting
1
n1 n2 n3 n4 (D)
n1 n2 n3 n4 (D)
n2 n3 n4 (D)
n2 n3 n4 (D)
1 to 239
254: The network designated at the valid module during access to another
station
0 to FE
H
1 to 8 (Constant)
Word device 7
1 to 64 (Constant)
81 to A0 : Group designation
H H
FF : Target network No. for all stations: excluding the host
H
Word device 7
When a group is designated, set the group No. of the target station with the
network parameters from GX Developer.
MELSEC-Q
Z: Executed when ON
ZP: Executed during start-up
Z: Executed when ON
ZP: Executed during start-up
Setting range
(Continued to the next page)
to A0 ) or all stations (FF ) is specified for the target
H H H
7 - 86