Installing the right control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the riser 1A
for Intel GPU configurations or
Steps
1. Align and slide the right control panel into the slot on the system.
2. Route the right control panel cable through the side wall of the system.
3. Align and slide the right control panel cable cover in the slot on the system.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
4. Connect the right control panel cable and VGA cable to the connectors on the system board.
5. Using the Phillips 1 screwdriver, tighten the screws that secure the right control panel and the cable cover to the system.
Figure 161. Installing the right control panel
Next steps
1.
Install the riser 1A
for Intel GPU configurations or
2. Follow the procedure listed in
Removing the left control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
174
Installing and removing system components
Safety
instructions.
Before working inside your
Remove the riser 1B
Install the riser 1B
After working inside your system
Safety
instructions.
Before working inside your
system.
for NVIDIA GPU configurations.
for NVIDIA GPU configurations.
.
system.