Installing The Ocp Card - Dell KGR3H Installation And Service Manual

Figure 109. Removing the OCP card
Next steps
Replace the OCP card.

Installing the OCP card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the expansion card
Steps
1. Open the blue latch on the system board.
2. Slide the OCP card into the slot in the system.
3. Push until the OCP card is connected to the connector on the system board.
4. Close the latch to lock the OCP card to the system.
Safety instructions.
Before working inside your
riser.
system.
Installing and removing system components 107