Table of Contents
Advertisement
Figure 127. Removing the M.2 SSD module
Next steps
If applicable,
Install the M.2 BOSS
Installing the M.2 SSD module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the BOSS
riser.
NOTE:
The procedure to install the M.2 SSD module is the same for Rear Accessed and Front Accessed configurations.
Steps
1. Align the M.2 SSD module at angle with the connector on the M.2 BOSS card.
2. Insert the M.2 SSD module until it is firmly seated in M.2 BOSS card connector.
3. Using the Phillips 1 screwdriver, secure the M.2 SSD module on the M.2 BOSS card with the screw.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
card.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
155
Advertisement
Table of Contents
