Table of Contents
Advertisement
5 Maintaining and Cleaning the
5
The
I
I
M
M
P
P
R
R
E
E
S
S
S
S
I
I
O
O
N
N
clean the air inlets and outlets as well as the optical LED lenses from time to time.
For safe operation it is absolutely essential that the fixture is kept clean and that dust,
dirt and smoke-fluid residues must not build up on, or within the fixture. Otherwise the
fixture's light-output will be significantly reduced or damages can occur. Regular
cleaning will not only ensure the maximum light-output, but will also allow the fixture
to operate reliably throughout its life.
A soft lint-free cloth moistened with any good glass cleaning fluid is recom-
mended, under no circumstances should alcohol or solvents be used!
5.1 Safety regulations
• Pull out the mains power plug!
• Wait min. 15 minutes after disconnecting power to allow the fixture to cool
down.
5.2 Maintenance and Interval (rule-of-thumb)
The contamination of the fixture depends on the environment details. Hence no
general guidelines can be given. The intervals given below are only suggestions
from our experience.
Position
LED reflector and optical system
Fan and air channel
Attention:
• Never let optical parts come into contact with oil or fat.
• Before running the fixture wait until all parts are dry.
• Never tough lenses with bare fingers.
GLP
German Light Products GmbH
X
X
4 is a fixture of very low maintenance. It is only necessary to
4
I
I
M
M
P
P
R
R
E
E
S
S
S
S
I
I
O
O
N
N
Interval
In this way
weekly
soft brush /lint-free cloth
monthly
vacuum cleaner, airbrush, etc.
(Instruction version: 1.0) / from software version: 1.18/18/12/10/n
X
X
4
4
18
Hide quick links:
Advertisement
Table of Contents
