Table of Contents
Advertisement
pencil tip and its reflection
Attention: Customized gobos like company logos, or those with writing also
need to be placed in the holder with the correct orientation to ensure that the
projected image reads correctly. Place the side of the gobo which reads
correctly towards the LED light engine to ensure that it projects properly.
Remember that the reflective side of the gobo should also be towards the LED
light source, so please instruct the gobo manufacturer accordingly when having
customized gobos made.
Glass Gobos with a structured surface must be mounted with the structured
surface towards the LED light source and the flat side towards the front lens.
5.2 Changing rotating gobos (wheel 1)
1. Attention: The fixture must be disconnected from the mains supply!
2. Open the fixture, using the quarter turn screws on the top cover.
3. Gobos are held in their respective holder by a metal spring alongside the
outer diameter. Remove this spring carefully using for example a small
screwdriver.
4. Take the gobo out of its holder. Pay attention not to drop it into the fixture.
5. Fit the new gobo into the holder securing it with the metal spring tightly.
6. Close the cover of the fixture again.
6 Maintaining and Cleaning the
6
The
V
O
L
K
S
L
I
C
H
T
V
O
L
K
S
L
I
C
H
T
the air inlets and outlets as well as the optical LED lenses from time to time. For safe
operation it is absolutely essential that the fixture is kept clean and that dust, dirt and
smoke-fluid residues must not build up on, or within, the fixture. If they do, the
fixture's light output will be significantly reduced, and damages to the fixture may
occur. Regular cleaning will not only ensure the maximum light output, but will also
allow the fixture to operate reliably throughout its entire life.
A soft lint-free cloth moistened with any good glass cleaning fluid is recom-
mended. Under no circumstances should alcohol or solvents be used to clean
the fixture or its lenses!
GLP
German Light Products GmbH
S
P
O
T is a low maintenance fixture. It is only necessary to clean
S
P
O
T
V
O
L
K
S
L
I
C
H
T
S
V
O
L
K
S
L
I
C
H
T
S
(Instruction version 1.01) / from software version 1.07
P
O
T
P
O
T
19
Advertisement
Table of Contents
