Rear Hub And Knuckle Installation; Rear Drive Shaft Removal - Linhai LANDBOSS LH800U-2D Service Manual

CHAPTER 4 FINAL DRIVE
2014.0
damage to the brake line.
5. Remove cotter pin, rear spindle nut, and washer.
6. Remove the upper and lower control arm bolts.
7. Slide the rear hub and knuckle from the rear drive
axle.
8. Inspect the rear hub and knuckle assembly by
hand for smoothness and side to side movement,
replace as needed.

4.10 REAR HUB AND KNUCKLE INSTALLATION

1. Start the rear hub and knuckle assembly onto the
drive shaft.
2. Align the bottom of knuckle and lower control arm.
Secure with the lower control arm bolt.
3. With the driveshaft placed in the knuckle, align
the knuckle with the top control arm. Secure with
the upper control arm bolt.
4. Torque the top and bottom A-arm bolts as shown
in the photo.
5. Install the washer and the spindle retainer nut.
6. Install the wheel and wheel nuts. Torque wheel
nuts to 69 ft.lbs. (95 Nm).
7. Lower the vehicle. Torque the spindle retaining
nut to 101 ft.lbs. (137 Nm). Install a new cotter
key.
8. Install brake caliper using new bolts. (Apply
Loctite™ 263 to threads) Tighten bolts to 18 ft.lbs
(24 Nm)

4.11 REAR DRIVE SHAFT REMOVAL

1. Repeat of the steps in the "REAR HUB AND
KNUCKLE REMOVAL" section.
2. Slide the rear drive axle out of the knuckle by
pulling the hub and knuckle assembly outward
and down.
LH800U-2D SERVICE MANUAL
CHAPTER 4 FINAL DRIVE. 4- 10