Record; Remote Record - LAIA TP-100 Administrator's Manual

Parameter Description
Configure the E1 work mode, the options are:
E1 work mode


Enable E1 dual Select whether to enable E1 dual video.
video
IP/E1 backup Select whether to enable IP/E1 backup.

8.8 Record

When using the terminal, you can record the main video source or HDMI-1 output of
the terminal, and the recorded video can be saved and played back. The terminal
supports two recording modes, namely remote recording and USB recording. Remote
recording is the terminal to store the recorded content on the recording server. USB
recording is the terminal to store the recorded content on the local USB flash drive.
Because the terminal recording resources are limited, remote recording and USB
recording cannot be used at the same time. When using one of them, please confirm
that the other one is not enabled.

8.8.1 Remote Record

Before using the remote recording function, you need to configure the recording mode,
recording server, and recording source.
Step 1 Enter the GUI main interface, select "Settings > Record > Remote Record".
Step 2 Configure remote record parameter information. The parameters are
described in the following table.
Step 3 Select "Save", save configuration information.
Step 4 End.
Parameter
Record Protocol
 Recording protocol is the parameter list of H.323
Copyright © 2021 Laia · www.laiatech.com
4E1: Extended mode
E1: Standard mode
Description
Select the record protocol, the options are:
H.323

RTMP

Setting
Default: H.323
47
Setting
Default: 4E1
Default: Enable
Default: Disable
All rights reserved