Qos - LAIA TP-100 Administrator's Manual

Parameter
Enable fixed
translator for NAT
traversal
Enable UDP hole
punching
When you Select "Enable fixed translator for NAT traversal", you need to set up the
router at the same time.
 Step
Step 1 Disable the ALG function in the router.
Step 2 It is set in the router to expose the terminal to the external network, and map
the terminal's TCP and UDP port ranges on the router.
Step 3 Enter the GUI main interface, select "Settings > Network > Firewall".
Step 4 Select "Enable fixed translator for NAT traversal" and enter the IP address of
the router's WAN port in the "Public IP" field.
Step 5 Select "Save", save configuration information.
Step 6 End.

8.1.3 QoS

Configure the IP service type (TOS) or maximum jitter buffer value and choose
whether to enable RTP packet loss recovery.
 Step
Step 1 Enter the GUI main interface, select "Settings > Network > QoS".
Step 2 Configure the QoS parameter information. The parameter description is
shown in the following table.
Step 3 Select "Save", save configuration information.
Step 4 End.
Copyright © 2021 Laia · www.laiatech.com
Description
When this function is enabled, terminals in the
private network will be treated as public network
terminals. After you enable static NAT, enter the
public IP address of the NAT device in the Public
Network Address field, select Static NAT Type, and
choose whether to enable automatic access to the
public network address.
When the media receives the port, it periodically
sends an empty UDP packet to traverse the NAT.
26
Setting
Default: Disabled
Default: Enabled
All rights reserved