Security - LAIA TP-100 Administrator's Manual

Parameter
Enable PoP
Enable PiP
Enable Side by Side
Layout when idle with
presentation
Layout when meeting
without presention
Layout when meeting with
presention
Layout when
embedded MCU meeting
Layout when
embedded MCU meeting
with presentation
In addition to pre-configuring the layout, you can also switch layouts in a
meeting in two ways:
Method 1

Switch the HDMI-1/SDI screen layout by pressing the display button
remote control.
Method 2

HDMI-1/SDI and HDMI-2 screens can be selected by selecting "Control > Video
Layout" on the GUI main interface.

8.6 Security

To prevent the loss and tampering of data content during communication, you can set
up encryption for communications.
Copyright © 2021 Laia · www.laiatech.com
Description
Choose whether to enable the paint side layout, if not enabled, all
the layouts of the draw side type will not be displayed.
Choose whether to enable the PiP layout. If not enabled, all PIP-
type layouts will not be displayed.
Choose whether to enable equal size layouts. If not enabled, all
layouts of the same size type will not be displayed.
Select the layout when there is an auxiliary stream state, and the
terminal will automatically switch to the layout when it enters this
state.
Select the layout when the conference has no auxiliary stream state,
and the terminal will automatically switch to the layout when it enters
this state.
Select the layout when the conference has the auxiliary stream state,
and the terminal will automatically switch to the layout when entering
the state.
When the built-in multi-point no-auxiliary state is selected, the
host
terminal will automatically switch to the layout when it enters this
state.
host Select the layout when the built-in multipoint has the auxiliary stream
state, and the terminal will automatically switch to the layout when it
enters this state.
42
on the
All rights reserved