Meeting Experience; Hold The Meeting - LAIA TP-100 Administrator's Manual

3

Meeting Experience

You can initiate a conference in a variety of ways. During the conference, you can
also perform conference control, send dual streams, and more.

3.1 Hold the Meeting

Start a conference after entering the IP address or number of the conference site,
selecting the call protocol, and the call rate on the call page.
 Step
Step 1 Enter the GUI main interface and enter the call prompt interface.
Step 2 Select the remote meeting, in the following ways:
Select the remote site to be called from the recent call in the center of

the call interface.
If the site to be called is not in the "recent call", you need to manually

fill in the remote site number or IP address.
Step 3 Configure the meeting parameters. The parameters are described in the
following table.
Parameter Description
Meeting/IP
Remote meeting number or IP address
Call Protocol Select the call protocol, the options are:
H.323

SIP

E1

Call Rate Select the call rate
Step 4 Select
Step 5 End.
Copyright © 2021 Laia · www.laiatech.com
.
Setting
The site/IP of the most recent call is
displayed by default.
Show recent call type by default
Optimal rate selection based on site
network conditions
14 All rights reserved