Co Measurement (Optional); Selecting The Cuvette Type; Checking The Co2 Sensor During; Ventilation - Dräger Oxylog 3000 plus Instructions For Use Manual

CO measurement (optional)
2
CO measurement only works when the CO
2
option has been installed and the CO
connected.
1 Connect the CO sensor and the cuvette (refer
2
to "Connecting the CO
on page 48).
2 Select the cuvette type in the settings menu
(refer to "Selecting the cuvette type").
The following will be activated:
– Curve window: CO
– Measured values window: the parameter etCO
will automatically be displayed.
– Alarm window: etCO
alarms
For more information on curves and measured
values: refer to "Enlarged view of CO
on page 34.
For more information on configuring measured
value pairs: refer to "Customer Service Mode"
on page 97.
For information on connecting the CO
cuvette, see page 48. For information on the CO
zero calibration and filter check before ventilation,
see page 58. For information on CO
in Customer Service Mode, see page 103.
Instructions for use Oxylog 3000 plus SW 1.n
2
sensor is
2
sensor and the cuvette"
2
curve
2
high and etCO low
2 2
curve"
2
sensor and
2
configuration
2

Selecting the cuvette type

NOTE
The cuvette windows of the reusable cuvette and
disposable cuvette have different optical proper-
ties. Therefore, the correct cuvette type must be
selected in the settings menu. Otherwise the zero
point will be shifted by as much as ±8 mmHg CO
To select the cuvette type (reusable or disposable):
1 Press the Settings
2 Select and activate the line Cuvette type.
3 Select the cuvette type and confirm.
2
NOTE
If a wrong cuvette type is selected,
Oxylog 3000 plus displays the alarm message
!!! Check cuvette type.

Checking the CO2 sensor during

ventilation

The following checks of the CO
recommended:
Check
2
CO zero calibration
2
CO filter check
2
Monitoring
key.
sensor are
2
Interval
Weekly
Monthly
.
2
91