Setting The Color Combinations; Setting Of Possible Color Combinations (Classic); Color Combinations With Active Function „Cycle Stroke Color S3/S4 Different - Pentair SUDMO IntelliTop 2.0 Operating Instructions Manual

LED - Color Assignments
17.1.

Setting the color combinations

17.1.1. Setting of possible color combinations (classic)

The color combinations will be set via the 4 color DIP switches (see "Fig. 32") after following scheme:
S1 S2
green yellow
yellow green
green red
red green
green yellow
yellow green
green red
red green
green yellow
yellow green
green red
red green
green yellow
yellow green
green red
red green
*) Color of S4 as S3 if function „cycle stroke color S3/S4 different" is not active
S4IN is always an open contact.
Delivered state DIP 1 - 4: each set to position 0
17.1.2. Color combinations with active function „cycle stroke color
S3/S4 different"
The function „cycle stroke color S3/S4 different" can be only (de-)activated via PC software. When the function
is active, position S4 flashes in another color as position S3, but with the same blinking pattern (250 ms ON,
250 ms OFF):
S1 S2
green yellow
yellow green
green red
red green
green yellow
yellow green
green red
red green
S3 S4 *) Fault
green
yellow
green yellow
red yellow
yellow
green
red yellow
green yellow
green green
yellow yellow
green green yellow
red red yellow
yellow yellow
green green
red red yellow
green green yellow
S3 S4 Fault
green yellow
yellow green
green red yellow
red green yellow
yellow green
green yellow
red green yellow
green red yellow
DIP1 DIP2
red 0 0
red 1 0
0 1
1 1
red 0 0
red 1 0
0 1
1 1
red 0 0
red 1 0
0 1
1 1
red 0 0
red 1 0
0 1
1 1
DIP1 DIP2
red 0 0
red 1 0
0 1
1 1
red 0 0
red 1 0
0 1
1 1
english
DIP3 DIP4
0 0
0 0
0 0
0 0
1 0
1 0
1 0
1 0
0 1
0 1
0 1
0 1
1 1
1 1
1 1
1 1
DIP3 DIP4
0 1
0 1
0 1
0 1
1 1
1 1
1 1
1 1
85