Table of Contents
Advertisement
Installer Manual Fleck 4600 SXT - Programming
4. Data display
5. PM indicator
6. Flow indicator
7. x1000 indicator
8. Programming icon
6.2.
Commands
A
Press
to pass to the next step.
B
Use
and
6.3.
Setting the time of the day (TD)
Set the time in the system.
A
Press and hold
icon and the parameter display reads TD.
B
Set the time with
C
Press
to validate the selection and return to the service mode, or wait
for 10 seconds.
6.4.
Basic programming
6.4.1. Day of Override (DO)
Determine the maximum number of days of operation without regeneration.
D
Press
and
sequence.
E
Select the number of days of Override with
F
Press
to validate the selection and advance to the next parameter.
6.4.2. Regeneration time (RT)
Determine the time of regeneration.
G
Adjust the regeneration time with
H
Press
to validate the selection and advance to the next parameter.
6.4.3. Feed Water Hardness (H)
Determine the feed water hardness in °tH.
I
Adjust the water hardness with
J
Press
to validate the selection and advance to the next parameter.
48 / 98
→ Appears if controller set in US unit.
→ Flashes when outlet flow is detected.
→ Appears when the displayed number is bigger than 9999.
→ Appears in programming modes.
to adjust the values.
or
until the programming icon replaces the service
or
.
simultaneously for 5 seconds to enter the menus
and
and
and
.
.
.
Ref. MKT-IM-028 / A - 03.07.2018
Advertisement
Table of Contents
