Programming Data - Pentair SUDMO IntelliTop 2.0 Operating Instructions Manual

11.8.

Programming data

The control heads have been configured as AS interface version with an extended address range (A/B slaves) for
62 slaves or optionally as an AS interface version for 31 slaves.
A change between the two configurations in the control head is only possibly by exchanging the elec-
tronic PCB!
If one control head is replaced with another control head having a different configuration in the AS interface
field bus system (e.g. AS interface version 62 slaves (A/B-Slave) to replace a device with AS interface version
31 slaves), a configuration error will be generated at the master due to the different ID codes!
In this case (intentional replacement!), the current configuration must be re-projected in the AS interface
master. Please read the operating instructions of the used AS interface master!
Factory setting AS-i address:
AS-i address = 0
Programming Data Table
I/O configuration
ID code
Extended ID code 1
Extended ID code 2
Profile
Bit configuration table
Data bit
Input
Output
Parameter bit
Output
54
Programming data for 62 Slaves
AS interface - Device for A/B slave
addressing (default device)
7 hex (4 inputs / 4 outputs)
see below: Bit configuration table
A hex
7 hex
E hex
S-7. A.E
D3 D2
External initiator S4 Position 3
Not used Solenoid valve 3
P3 P2
Not used Not used
english
AS Interface - Design
Programming data for 31 Slaves
AS interface (optional)
7 hex (4 inputs / 4 outputs)
see below: Bit configuration table
F hex
(F hex)
(F hex)
S-7. F.F
D1 D0
Position 2 Position 1
Solenoid valve 2 Solenoid valve 1
P1 P0
Not used Not used