Changing The Electronics Module - Pentair SUDMO IntelliTop 2.0 Operating Instructions Manual

Control head
Table of Contents

Advertisement

Replacement of Components and Modules
20.2.

Changing the electronics module

NOTE!
Electrostatic sensitive components/modules!
• The device contains electronic components which react sensitively to electrostatic discharge (ESD). Contact
with electrostatically charged persons or objects may be hazardous to these components. In the worst case
scenario, they will be destroyed immediately or will fail after start-up.
• Observe the requirements in accordance with DIN EN 61340-5-1 to minimize or avoid the possibility of damage
caused by sudden electrostatic discharge!
• Also ensure that you do not touch electronic components when the supply voltage is on!
Removal procedure:
Open the housing following the instructions in Chapter "8. Opening and Closing the Housing".
If necessary, mark the electrical connections to ensure correct assignment during reinstallation!
If required, note the position of the DIP switches for the set color code and the DIP switches (8-switch block)
on the DeviceNet electronics module for baud rate and address. On the AS-i electronics module, note the AS
interface address and the jumper positions (power supply to AS interface).
If required, read out and note special settings by PC software.
Loosen all electrical connections on the electronics module (plug-type connections, screw-type terminal
connections).
Loosen the screw-type connection (Torx T10 screw) of the electronics module and store the screw in a safe
place.
Carefully press the electronics module forwards so that the contact pins on the position measuring system are
exposed.
Connection for the
position measuring
system's contact pins
AS interface power
Electronics module,
(sealed lower part,
ready for installation)
Fig. 35:
Electronics module (here example of AS interface)
Carefully lift the electronics module upwards.
Jumper for
supply
complete
Fastening screw
(Torx 10)
4 DIP switches for
color coding
Plug-type connections
for valves V1-3
english
97

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2307193

Table of Contents