Set Communication - ADF Web HD67604-A1 User Manual

Industrial Electronic Devices

SET COMMUNICATION:

This section defines the fundamental communication parameter of two buses, PROFIBUS and PROFINET.
By pressing the "Set Communication" button from the main window for SW67604 (Fig. 2) the window
"SET COMMUNICATION" appears (Fig. 3).
The window is divided in two sections, one for the PROFIBUS and the other for the PROFINET.
The means of the fields for "PROFIBUS" are:
In the field "ID Dev." the address of the PROFIBUS side is defined;
In the field "Baud rate" the baud rate for the PROFIBUS side is defined;
The means of the fields for "PROFINET" are:
In the fields "IP" insert the IP address that you want to give to the Converter;
In the fields "SUBNET
In the fields "GATEWAY" insert the default gateway that you want to use. This feature can be
enabled or disabled pressing the Check Box field. This feature is used for going out of the net;
In the field "Port" the port used for PROFINET communication is defined. The port has a fixed value
of 34964;
In the field "PROFINET Name of
ADFweb.com Srl – IT31010 – Mareno – Treviso
Mask" insert the Subnet Mask;
Station" is possible to assign a name to the PROFINET node.
User Manual PROFINET / PROFIBUS Master - Converter
Document code: MN67604_ENG Revision 1.001 Page 14 of 33
Figure 3: "Set Communication"
window