ADF Web HD67604-A1 User Manual page 26

Industrial Electronic Devices
If you know the actual IP address of the device you have to use this procedure:
Turn on the Device with the Ethernet cable inserted;
Insert the actual IP of the Converter;
Press the "Ping" button, must appear "Device Found!";
Press the "Next" button;
Select which operations you want to do;
Press the "Execute update
When all the operations are "OK" the device automatically goes at
Normal Mode.
At this point the configuration/firmware on the device is correctly update.
Note:
When you install a new version of the software it is better if the first time you do the update of the Firmware in the HD67604-A1
device.
Note:
When you receive the device, for the first time, you have to update also the Firmware in the HD67604-A1 device.
Warning:
If the Fig. 15 appears when you try to do the Update before require assistance
try these points:
Try to repeat the operations for the updating;
Try with another PC;
Try to restart the PC;
If you are using the program inside a Virtual Machine, try to use in the main
Operating System;
If you are using Windows Seven or Vista or 8, make sure that you have the
administrator privileges;
Take attention at Firewall lock;
Check the LAN settings.
In the case of HD67604-A1 you have to use the software "SW67604": www.adfweb.com\download\filefold\SW67604.zip.
ADFweb.com Srl – IT31010 – Mareno – Treviso
firmware" button to start the upload;
User Manual PROFINET / PROFIBUS Master - Converter
Document code: MN67604_ENG
Figure 15: "Protection" window
Revision 1.001 Page 26 of 33