Module Selection - ADF Web HD67604-A1 User Manual

Industrial Electronic Devices
M S :
ODULE ELECTION
The section "Module Selection" is used to select
which Modules are present in the Slave (Fig. 7).
In this section is possible to:
Check the list of the Modules selected
("Select Modules") (Fig. 7, point (1)) and the
list of Modules Available
("Available Modules") (Fig. 7, point (7));
Add a Module from the list of GSD file (Fig. 7,
point (6));
Remove a Module from selected list (Fig. 7,
point (5));
Add all Modules present in the GSD file (Fig.
7, point (4));
Remove all Modules from selected list (Fig. 7,
point (3));
Insert a Module not present in the GSD file
("Manual Module") (Fig. 7 point (2)). For
more info see the section "Manual Module"
below;
Enable the read of configuration directly from
the PROFIBUS Slave
configuration readed from
7, point (8)). If this option is enable the
configuration of the modules is discorded and
the device read the correct configuration
directly to the PROFIBUS slave.
Figure 7: "PROFIBUS Device – Module Selection"
window
ADFweb.com Srl – IT31010 – Mareno – Treviso
in GSD file
("Use
module
device") (Fig
User Manual PROFINET / PROFIBUS Master - Converter
Document code: MN67604_ENG Revision 1.001 Page 18 of 33