Table of Contents
Advertisement
Industrial Electronic Devices
PROFIBUS:
The PROFIBUS uses a 9-pin D-SUB connector. The pin assignment is defined
like in the right figure.
Here some codes of cables:
Belden: p/n 183079A - Continuous Armor DataBus® ISA/SP-50
PROFIBUS Cable.
PROFINET:
The PROFINET connection must be made using Connector3 and/or Connector4 of HD67604-A1 with at least a Category 5E cable. The
maximum length of the cable should not exceed 100m. The cable has to conform to the T568 norms relative to connections in cat.5 up to
100 Mbps. To connect the device to an Hub/Switch is recommended the use of a straight cable, to connect the device to a PC/PLC/other is
recommended the use of a cross cable.
ADFweb.com Srl – IT31010 – Mareno – Treviso
User Manual PROFINET / PROFIBUS Master - Converter
Document code: MN67604_ENG
Revision 1.001
Page 10 of 33
Advertisement
Table of Contents
