Table of Contents
Advertisement
To make a performance start in
"Launch Control" mode, the following
conditions must be met:
• Water and transmission temperature
in proper range.
• No engine, AWD and on board
systems faults.
• The vehicle must be traveled at least
700 km (440 mi).
• "CORSA" drive mode on.
• Shift lever in "D" or"M +/-" position.
• The vehicle must be stationary on a
level road surface.
• The driver door closed and the safety
belt fastened.
Launch Control Sequence
NOTE:
• All the above mentioned conditions
must be verified in order to activate
"Launch Control" performance start
procedure.
• During "Launch Control" ACC,
FCW and HAS (if equipped) are
temporarily disabled.
• Each step displayed on the
instrument cluster has a time out
approximately of 5 seconds.
• "Launch Control" maneuver requires
to use both foot, left foot to brake
and right foot to accelerate at the
same time.
• With engine on, parking brake
disengaged, brake pedal pressed and
steering wheel straight, pull "–" left
paddle. The instrument cluster shows
the "Launch Control" engaged page.
• To confirm the procedure, pull again
the "–" paddle down. To abort the
procedure, pull "+" right paddle.
• To confirm the "Launch Control"
sequence, press full the brake pedal
as indicated in the message on the
instrument cluster.
• With brake pedal pressed full with
left foot, press full the accelerator
pedal (with right foot) as indicated
in the message on the instrument
cluster.
• Release brake pedal. The launch
of the vehicle starts with ESC that
manages the maximum performance
and engine torque calibrated to
maximize performance. Maximum
performance is achieved if driver let
the engine rpm stall above 2300 rpm
before releasing brake pedal.
Driving
5
259
Advertisement
Table of Contents
