Launch Control Mode - Maserati GranTurismo 2024 Owner's Manual

Launch Control Mode

"Launch Control" mode is a performance
start procedure. By activating this
procedure you get the best possible
acceleration from standstill of the car.
This mode allows you to ground the
torque necessary to prevent the wheels
from slipping during acceleration
performance.
To make a performance start in "Launch
Control" mode, the following conditions
must be met:
• Water and transmission temperature in
proper range.
• No engine, AWD and on board systems
faults.
• "SPORT" or "CORSA" drive mode on.
• Transmission in "D".
• The vehicle must be stationary on a
level road surface.
• The driver door closed and the safety
belt fastened.
Launch Control Sequence
NOTE:
• All the above mentioned conditions
must be verified in order to activate
"Launch Control" performance start
procedure.
• During "Launch Control" ACC (if
equipped), FCW and ADA (if equipped)
are temporarily disabled.
• Each step displayed on the instrument
cluster has a time out approximately of
5 seconds.
• "Launch Control" maneuver requires
to use both feet, left foot to brake and
right foot to accelerate at the same
time.
• With engine on, parking brake
disengaged, brake pedal pressed and
steering wheel straight, pull "+" right
paddle. The instrument cluster shows
the "Launch Control" engaged page.
• To confirm the procedure, pull again the
"+" paddle. To abort the procedure, pull
"-" left paddle.
• To confirm the "Launch Control"
sequence, press full the brake pedal
as indicated in the message on the
instrument cluster until the green zone
of the brake pressure percentage bar is
reached.
Driving and Driver Assistance Systems
• With brake pedal pressed full with left
foot, fully press the accelerator pedal
(with right foot) as indicated in the
message on the instrument cluster.
• Release brake pedal. The launch of the
vehicle starts with ESC that manages
the maximum performance and
engine torque calibrated to maximize
performance. Maximum performance is
achieved if driver let the engine rpm
stall above 2500 rpm before releasing
brake pedal.
5
211