Table of Contents
Advertisement
Driving
If the hooking and/or the electrical
connection between vehicle and trailer
is faulty, the warning light and the
relevant message are displayed on
instrument cluster display (see example
in the figure).
5
In these cases please contact the
Service Network and avoid using the
vehicle with a trailer.
Installing the Trailer Tongue
Removing the Access Cover
Before fitting the trailer tongue, the
access cover on the bottom part of the
rear bumper must be removed.
The cover is engaged in the bumper.
• Release cover inner side from
bumper, using the tip of a tool or
screwdriver at the points indicated by
the arrows.
342
• Slide cover downward to disengage
the two projecting elements
indicated in the figure from bumper.
• Store cover in the luggage
compartment.
Install the Trailer Tongue
• Remove the protective plug from
the trailer tongue seat on the cross
member of the car.
On cars equipped with tire kit:
• lift the rear side of boot floor panel
and hold it up in one of the available
positions (see "Tool Kit" in section
"In an Emergency");
• remove the storage box: the trailer
tongue is installed in the preformed
tool box.
On cars equipped with spare wheel,
the trailer tongue is housed in a bag
positioned on the right side of the
boot compartment.
The trailer tongue is usually in the
released position
when taken out
from the luggage compartment. This
can be observed by the knob spaced
of approximately 5 mm (0.2 in) from
the bar of trailer tongue (shown in
the side view of figure) and by the
red mark on the knob directed to the
green mark on the bar. The trailer
Advertisement
Table of Contents
