Table of Contents
Advertisement
Before Starting
• "Remote Start Cancelled Fuel Low".
• "Remote Start Cancelled Time
Expired".
• "Remote Start Disabled Start Vehicle
to Reset".
2
The message on the instrument cluster
stays active as long as the ignition
switch is in RUN position.
To enter Remote Start Mode
NOTE:
On the key fob RKE transmitter
of vehicles with this function, the
external lights button
by the remote start button
Press and release the button
the key fob RKE transmitter twice
within five seconds. The vehicle
doors will lock, position lights will
flash and the horn will ring twice (if
this function is set using the MTC+
System, refer to "MTC+ Settings" in
section "Dashboard Instruments and
Controls"). Then, the engine will start
and the vehicle will remain in the
"Remote Start" mode for a 15-minute
cycle.
28
NOTE:
• In case of an engine fault or low fuel
level, the vehicle will start and then
is replaced
shut down in 10 seconds.
.
• The park lights will turn on and
remain lighted up during "Remote
on
Start" mode.
• For security reasons, power window
and power sunroof operation (if
equipped) are disabled when the
vehicle is in the "Remote Start"
mode.
• The engine can be started two
consecutive times (two 15-minute
cycles) with the key fob RKE
transmitter. However, the ignition
must be cycled to the RUN position
before you can repeat the start
sequence for a third cycle.
To exit Remote Start Mode
without Driving the Vehicle
Press and release the button
time or allow the engine to run for the
entire 15-minute cycle.
NOTE:
To avoid unintentional shutdowns, the
system will disable the one time press
of the button
for two seconds
after receiving a valid "Remote Start"
request.
To exit Remote Start Mode and
Drive the Vehicle
Before the end of the 15-minute cycle,
press and release the button
key fob RKE transmitter to unlock the
doors and disarm the vehicle security
alarm. Then, prior to the end of the
15-minute cycle, press and release the
START/STOP button.
NOTE:
The message "Remote Start Active
Push Start Button" will display in the
instrument cluster until you push the
START/STOP button.
Auto-On Comfort with Remote
Start
The driver's heated and ventilated
seat and the heated steering wheel
(if foreseen) can be programmed to
one
on the
Advertisement
Table of Contents
