Table of Contents
Advertisement
Understanding the Vehicle
beams until the approaching vehicle is
out of view.
Futhermore, the digital camera is able
to detect the urban areas and the
inhabited centers and to turn off the
high beams when driving near of one
of them.
The properly working for this feature
(if all the other conditions are met) is
3
ensured between 35 km/h (21.7 mph)
and 250 km/h (155 mph).
Activation Mode
To activate Automatic High Beam
feature:
• Shift the multifunction lever onward
.
• Put the light switch in "AUTO"
position.
• Touch the "Controls" soft-key in the
(Apps) page of lower part of the
MTC+ display.
• Within 15 seconds, touch the "Auto
High Beam Assist" soft-key to turn on
the feature.
114
Without ADAS
With ADAS
• Within 15 seconds, touch the "Auto
High Beam Assist" soft-key a second
time to turn it off.
After these steps, the green indicator
on the upper right side of the TFT
display comes on.
NOTE:
• The function is enabled only if the
brightness sensor detects the right
lighting conditions and them switch
to low beam on.
• Broken, muddy, or obstructed
headlights and taillights of vehicles in
the field of view will cause headlights
to remain on longer (closer to the
vehicle). Also, dirt, film, and other
obstructions on the windshield or
camera lens will cause the system to
function improperly.
Automatic High Beam Failure
In the event of an automatic high
beam system failure, the related
amber warning light will light up on
the TFT display.
Take your vehicle to the nearest
Center of the Service Network as soon
as possible avoiding to use this system.
Advertisement
Table of Contents
