Table of Contents
Advertisement
Dashboard Instruments and Controls
Tire Pressure Monitoring Light
This warning light is connected
to the Tire Pressure Monitoring
System (TPMS).
Under normal conditions, the
warning light should illuminate when
the ignition switch is in RUN and
should go off as soon as the engine is
started.
If the warning light remains lit or
illuminates while driving, the pressure
of one or more tires is too low and a
message will be displayed.
4
The TPMS malfunction warning light
is connected to the low tire pressure
monitoring light.
When the system detects a
malfunction, the monitoring light
and the related message will flash for
approximately one minute and then
remain lit.
This sequence will continue upon
subsequent vehicle start-ups as long as
the malfunction lasts.
When the malfunction warning light
lights up, the system may not be able
to detect or signal low tire pressure
correctly.
Please refer to "Tire Pressure
Monitoring System (TPMS)" in section
"Driving" for further information.
154
Anti-Lock Braking System (ABS)
Malfunction Warning Light
This light, and its related
message, indicate possible
malfunctions of the Anti-Lock
Braking System (ABS).
The light will turn on when the
ignition switch is in RUN position
and may stay on for 4 seconds. If
the ABS light remains lit or turns on
while driving, the Anti-Lock portion
of the brake system is not functioning
and requires service. However, the
conventional brake system will
continue to operate normally if the
warning light is switched off.
If the ABS light turns on while driving,
or if it does not switch on when the
ignition switch is in RUN position,
please visit as soon as possible a
Service Centre in order to restore the
Anti-Lock brakes functions.
Electronic Stability Control (ESC)
Activation/Malfunction Indicator Light
The ESC activation/malfunction
indicator light on the
instrument cluster will display
when the ignition switch is in RUN
position.
It should switch off by starting the
engine.
If the light stays on with the engine
running, there is a malfunction in the
ESC system.
If the light still stays on after several
ignition cycles, and the vehicle has
been driven for several kilometers at
more than 48 km/h (30 mph) visit the
Service Network as soon as possible
to have the problem diagnosed and
restored.
NOTE:
Each time the ignition switch is in RUN:
• The ESC OFF indicator light
the ESC activation/malfunction
indicator light illuminates
temporarily.
• The ESC system will be on, even if
it was turned off previously. The
ESC system will make buzzing or
clicking sounds when active. This is
normal; the sounds will stop when
ESC becomes inactive by solving
the problem that caused the ESC
activation.
Electronic Stability Control (ESC) OFF
Indicator Light
This indicator notifies that
the Electronic Stability Control
(ESC) is disabled (OFF); the
linked message will be displayed.
and
Advertisement
Table of Contents
