Table of Contents
Advertisement
switch down to open the window
completely.
Open and Close the Windows
and Sunroof with RKE
Transmitter and Ignition Off
When the ignition switch is in OFF
position, windows and sunroof (if
equipped) can be opened or closed
by pressing the buttons on the RKE
transmitter.
Opening:
• press the
button and release it;
• press a second time the
and keep it pressed until complete
opening of the window and sunroof,
if they were closed.
Closing:
• press the
button and release it;
• press a second time the
and keep it pressed until complete
closure of the window and sunroof, if
they were open.
Rear Window and Sunshade
Lockout Button
The window lockout button on the
driver's door trim panel allows to
disable the window and sunshade
control on the rear doors by pressing
the window lockout button (setting it
in the down position).
To enable the controls previously
described, press the window lockout
button again (setting it in the up
position).
button
Wind Buffeting
Wind buffeting can be described
as the perception of pressure or a
helicopter-type sound. Your vehicle
may exhibit wind buffeting with
button
the windows down, or the sunroof
(optional) in open or partially open
positions. This is a normal occurrence
and can be minimized. If the buffeting
occurs with the rear windows open,
open the front and rear windows
together to minimize the buffeting. If
the buffeting occurs with the sunroof
open, then adjust the sunroof opening
to minimize the buffeting.
Before Starting
Power Sunshades on Rear
Door Windows (optional)
NOTE:
• On vehicles provided with power
sunshades on the rear windows, the
window switches also operate the
sunshades.
• The rear windows lock button
operates as well the rear power
sunshades.
• The window and sunshades controls
will operate only if the ignition
switch is in ACC or RUN position.
Operation of the rear windows
and related sunshades is done by
pressing or pulling the window switch
and depends on the position of the
windows prior to the command
operation.
As described for the opening and
closing functions of the power
windows (see chapter "Power
Windows" in this section), the
windows switch has two functioning
modes: press and release the switch to
the first detent to partially move the
window; press and release the switch
to the second detent to move the
window all the way up or down.
2
37
Advertisement
Table of Contents
