Table of Contents
Advertisement
Assist - LKA" and "Highway Assist -
HAS" in section "Driving".
Forward Collision Warning (FCW) Off
This warning light informs the
driver that Forward Collision
Warning (FCW) is disabled.
This might occur when front
sensor and/or the ACC/FCW system
sensors are malfunctioning and need
cleaning or servicing and when
ACC/FCW system is not available due
to a system error (for further details,
refer to "Adaptive Cruise Control -
ACC" in section "Driving").
This warning light will light even
when the activation of another driver
assistance feature or drive mode (such
as "
- ESC OFF") disables the FCW.
Forward Collision Warning (FCW) Fault
This warning light informs that
FCW is in fault state. If this
occurred together with other
specific messages, could mean that a
system fault requiring servicing at the
Service Network.
It is nevertheless possible to drive the
vehicle without using this function
(for further details, refer to "Forward
Collision Warning - FCW" in section
"Driving").
General Fault for Driving with a Trailer
(NOT for TROFEO version)
The warning light and the
relevant message are displayed
to indicate a fault or failure of
the connection between vehicle and
trailer. In these cases please contact
the Service Network as soon as
possible, and avoid using the vehicle
with a trailer.
AWD Failure Warning Light
This warning light turns on to
indicate a fault of the AWD
system otherwise a fault or
overheating due to excessive wheel
spin. Contact the Service Network as
soon as possible, and avoid using the
vehicle in heavy duty conditions.
Set Passive Speed Limit
This warning light indicates the
passive speed limit set via the
controls on the RH side of the
steering wheel (for further details,
refer to "TFT Display: Menus and
Settings" in this chapter).
Passive Speed Limit Exceeded
This warning light informs the
driver that the speed limit that
was set has been exceeded.
Dashboard Instruments and Controls
Stiff Suspension Setting Indicator
This indicator light indicate
that the stiff suspensions
program ("S") is on. For further
details, refer to "Drive Mode" in
section "Driving".
Set Drive Mode Indicator
Drive mode set by the driver
through the controls on central
console is displayed above the
transmission lever indicator (example
in picture: NORMAL).
For further details, refer to "Drive
Mode" in section "Driving".
Ride Height Indicator for Vehicle Setup
Ride height set through the
control on central console is
always displayed in the specific
area on the RH side of the TFT display.
From the "Normal" level (shown in
picture) ride height can be lowered
at "Aero 1" or "Aero 2" levels when
using vehicle on the road. When using
the vehicle off road, ride height can
be set to a higher position thanks to
"Off Road 1" or "Off Road 2" levels.
For further details, refer to "Drive
Mode" and "Off-road Drive" in section
"Driving".
The lowest position
"Entry/Exit" shown in picture
4
177
Advertisement
Table of Contents
