Table of Contents
Advertisement
• If enabled, disable the automatic
engagement function of electric
parking brake (see "Parking Brake"
in section "Driving").
• Shift the gearshift lever to N
(Neutral).
• The brake pedal can be pressed or
not pressed.
• Turn the engine off by pressing the
START/STOP button for 5 seconds.
Through these steps, the driver's door
must be closed. This condition will
persists for about 25 minutes, the shift
lever will switch to P (Park) once time
has expired.
In case of low-battery voltage the shift
lever can be placed in P (Park) before
this time has expired.
NOTE:
It is also appropriate to disable the
"Passive Entry" function from the
MTC+ system so that the "Pre-Short
Drop" function will not be activated.
This can prevent water from entering
in the passenger compartment during
car washing.
WARNING!
•
Performed this procedure the
vehicle will stay in N (Neutral),
rather without any brake. To avoid
accidental movement, always check
that the movement of the vehicle
take place only on a flat surface.
•
DO NOT USE this mode to haul the
vehicle because after a period of
time the shift lever will be placed
automatically in P (Park) position.
If this occurs when the vehicle is
moving the transmission can be
damaged. To haul the vehicle use the
emergency manual park release (see
"Transmission Manual Release of P
(Park) Position" in section "In an
Emergency").
Pre-Short Drop Function
When in a car washing, if the driver
keeps the RKE Transmitter in his/her
pocket, or in any place outside the
vehicle within 1 m (3.3 ft) distance, the
front windows will perform a pre-short
drop. This is a shorter drop compared
to the normal short drop performed
by the "Passive Entry" function when
you grab the door handle to enter the
vehicle.
In order to prevent water from
entering the vehicle between the
Maintenance and Care
upper edge of the glass window and
the door outline on the bodywork,
while the car is being washed, it is
advisable to disable the "Passive
Entry" from the MTC+ System,
for further information refer to
chapter "MTC+ Settings" in section
"Dashboard Instruments and controls".
When deactivating the "Passive Entry",
also the "Pre-Short Drop" function will
be disabled.
7
411
Advertisement
Table of Contents
