Understanding the Vehicle
(Continued)
"Vehicle security alarm" in section
"Before Starting").
WARNING!
•
Your motorized door or gate
will open and close while you
are programming the universal
3
transceiver. Do not program the
transceiver if people, pets or other
objects are in the path of the door or
gate. Only use this transceiver with
a garage door opener that has a
"stop and reverse" feature. Do not
use a garage door opener without
these safety features. Call toll-free
1–800–355–3515 or, on the Internet
at www.HomeLink.com for safety
information or assistance.
•
Vehicle exhaust contains carbon
monoxide, a dangerous gas. Do
not run your vehicle in the garage
while programming the transceiver.
Exhaust gas can cause serious injury
or death.
Before You Start Programming
®
HomeLink
Be sure that your vehicle is parked
outside of the garage before you
begin programming.
144
For more efficient programming and
accurate transmission of the radio-
frequency signal it is recommended
that a new battery be placed in the
hand-held transmitter of the device
that is being programmed to the
HomeLink
®
system.
Before starting programming it is
necessary to erase the standard codes
memorized on the HomeLink
during the production phase. To erase
such codes:
• place the ignition device in the RUN
position without starting the engine;
• press and hold the two outside
HomeLink
®
buttons (I and III) until
the warning light starts flashing
(after approximately 20 seconds);
• release the buttons.
NOTE:
• Erasing the standard codes
should only be performed when
®
programming HomeLink
for the first
time. Do not perform this operation
to program additional buttons.
• If you have any problems, or
require assistance, please call
toll-free 1 – 800 – 355 – 3515 or, on the
Internet at www.HomeLink.com for
information or assistance.
®
device
System with Devices Provided
with Rolling Codes
Programming the Hand-held
Transmitters Manufactured after 1995
These devices can be identified by the
"LEARN" or "TRAIN" setting button
located where the hanging antenna
is attached to the garage door/gate
opener. It is NOT the button that is
normally used to open and close the
door.
The name and color of the button may
vary by manufacturer.
• Place the ignition device to the RUN
position without starting the engine.
• Place the hand-held transmitter 5
- 30 cm (1 to 3 inches) away from
the HomeLink
program.
• Simultaneously press the Homelink
button you want to program and the
hand-held transmitter button.
®
button you wish to
®