Homelink (For Versions/Markets, Where Provided) - Maserati Ghibli Owner's Manual

Understanding the Vehicle
®
HomeLink (for
versions/markets, where
provided)
®
HomeLink replaces up to three
hand-held transmitters that operate
devices such as garage door openers,
motorized gates, lighting or home
3 security systems. The HomeLink
is powered by your vehicles 12 Volt
battery. The HomeLink
are located in the overhead console
designate the three different
®
HomeLink channels. The HomeLink
indicator is located above the center
button.
NOTE:
®
HomeLink is disabled when the
vehicle security alarm is active (see
"Vehicle security alarm" in section 2).
122
WARNING!
• Your motorized door or gate will
open and close while you are
programming the universal
transceiver. Do not program the
transceiver if people, pets or other
objects are in the path of the door or
®
unit
gate. Only use this transceiver with a
garage door opener that has a "stop
®
buttons that
and reverse" feature. Do not use a
garage door opener without these
safety features. Call toll-free
®
1–800–355–3515 or, on the Internet
at www.HomeLink.com for safety
information or assistance.
• Vehicle exhaust contains carbon
monoxide, a dangerous gas. Do not
run your vehicle in the garage while
programming the transceiver.
Exhaust gas can cause serious injury
or death.
Before You Start Programming
HomeLink
Be sure that your vehicle is parked
outside of the garage before you
begin programming.
For more efficient programming and
accurate transmission of the
radio-frequency signal it is
®
recommended that a new battery be
placed in the hand-held transmitter of
the device that is being programmed
®
to the HomeLink system.
Erase all channels before you begin
programming. To erase the channels
place the ignition device in the RUN
position and press and hold the two
®
outside HomeLink buttons (I and III)
for up 20 seconds. The instrument
cluster will display "CLEARING
CHANNELS".
Release the buttons when the
instrument cluster displays "CHANNELS
CLEARED".
NOTE:
• Erasing all channels should only be
performed when programming
®
HomeLink for the first time. Do not
erase channels when programming
additional buttons.
• If you have any problems, or require
assistance, please call toll-free
1–800–355–3515 or, on the Internet
at www.HomeLink.com for
information or assistance.