Table of Contents
Advertisement
WARNING!
•
Your motorized door or gate
will open and close while you
are programming the universal
transceiver. Do not program the
transceiver if people, pets or other
objects are in the path of the door or
gate. Only use this transceiver with a
garage door opener that has a "stop
and reverse" function as required
by Federal safety standards. This
includes most garage door opener
models manufactured after 1982.
Do not use a garage door opener
without these safety functions. Call
toll-free 1–800–355–3515 or, on the
Internet at www.HomeLink.com for
safety information or assistance.
•
Vehicle exhaust contains carbon
monoxide, a dangerous gas. Do
not run your vehicle in the garage
while programming the transceiver.
Exhaust gas can cause serious injury
or death.
Before You Start Programming
HomeLink
®
Be sure that your vehicle is parked
outside of the garage before you
begin programming.
For more efficient programming and
accurate transmission of the radio-
frequency signal it is recommended
that a new battery be placed in the
hand-held transmitter of the device
that is being programmed to the
HomeLink
®
system.
Before starting programming it is
necessary to erase the standard codes
memorized on the HomeLink
during the production phase. To erase
such codes:
• place the ignition device in the RUN
position without starting the engine;
• press and hold the two outside
®
HomeLink
buttons (I and III) until
the indicator light starts flashing
(after approximately 20 seconds);
• release the buttons.
NOTE:
• Erasing the standard codes
should only be performed when
programming HomeLink
®
time. Do not perform this operation
to program additional buttons.
• If you have any problems, or
require assistance, please call
toll-free 1 – 800 – 355 – 3515 or, on the
Internet at www.HomeLink.com for
information or assistance.
Understanding the Vehicle
®
device
System with Devices Provided
with Rolling Codes
Programming the Hand-held
Transmitters Manufactured after 1995
These devices can be identified by the
"LEARN" or "TRAIN" setting button
located where the hanging antenna
is attached to the garage door/gate
opener. It is NOT the button that is
normally used to open and close the
for the first
door.
The name and color of the button may
vary by manufacturer.
• Place the ignition device to the RUN
position without starting the engine.
• Place the hand-held transmitter 1
to 3 inches (5 - 30 cm) away from
the HomeLink
program.
• Simultaneously press the Homelink
button you want to program and the
hand-held transmitter button.
®
button you wish to
®
2
55
Advertisement
Table of Contents
