Differential, Adjusting - Volkswagen Golf 2015 Repair Manual

Golf 2015 ➤ , Golf Variant 2015 ➤
Manual Transmission - Edition 02.2016
Installing the Spring Pin for the Differential Bevel Gear Axle
– Align the hole in the differential bevel gear axle to the hole in
the differential housing.
– Using a drift, install the adapter sleeve -1- to the dimension
-a- = 2.5 ± 0.5 mm.
2.3

Differential, Adjusting

Special tools and workshop equipment required
♦ Transmission Support - VW353-
♦ Measuring Set - Magnetic Plate - 50mm - VW385/17-
♦ Dial Gauge Holder - VW387-
♦ Press Plate - VW402-
♦ Press Piece - Rod - VW408A-
♦ Press Piece - Multiple Use - 3005-
♦ Press Piece - Bushing - 3259-
♦ Bearing Installer - Wheel Bearing - 3345-
♦ Torque Wrench 1331 5-50Nm - VAG1331-
♦ Puller - Kukko Internal - 46-56mm - 21/7-
♦ Counter Support - VAS251623-
♦ Puller - Kukko Counterstay - 22/2-
♦ Dial Indicator - VAS6080A-
♦ 30 mm Dial Gauge Extension
A New Differential Adjustment is Required When the Following
Components Have Been Replaced:
♦ Transmission Housing
♦ Clutch Housing
♦ Differential housing or
♦ Differential tapered roller bearing
Adjustment Overview. Refer to
⇒ 3 Adjustment Overview , page 221
– Pressing outer race/tapered roller bearing with shim into clutch
housing -Item 8- ⇒ Item 8 (page 213)
Note
Pay attention to the shim installed position.
♦
The collar on the inner circumference faces the seal.
♦
218
Rep. Gr.39 - Final Drive, Differential
.
.