Volkswagen Golf 2015 Repair Manual page 47

2.2.2 Overview - Clutch, with Dual Mass Flywheel, LuK
1 - Dual Mass Flywheel
❑ Make sure it fits secure‐
ly on the centering pins
❑ Keep the clutch lining
contact surface free of
grooves, oil and grease.
❑ Removing and instal‐
ling. Refer to ⇒ Engine
Mechanical, Fuel Injec‐
tion and Ignition; Rep.
Gr. 13 ; Cylinder Block,
Transmission Side; Fly‐
wheel, Removing and
Installing .
2 - Clutch Plate
❑ Only replace together
with the SAC pressure
plate
❑ Allocation. Refer to the
Parts Catalog.
❑ Removing and instal‐
ling. Refer to
⇒ 2.3.2 Clutch, Remov‐
ing and Installing, with
Dual Mass Flywheel,
LuK , page 48 .
❑ Installed position. Refer
to
⇒ Fig. Clutch Plate In‐
stalled Position ,
page 49
3 - SAC Pressure Plate
❑ Only replace together
with the clutch plate
❑ SAC = Self Adjusting
Clutch
❑ Allocation. Refer to the Parts Catalog.
❑ Removing and installing. Refer to
⇒ 2.3.2 Clutch, Removing and Installing, with Dual Mass Flywheel, LuK , page 48
❑ Check the ends of the diaphragm spring. Refer to
⇒ Fig. Check the Ends of the Diaphragm Spring , page 50
❑ Checking the spring connections and rivet connections. Refer to
⇒ Fig. Checking the Spring Connections and Rivet Connections , page 50
❑ Release bearing with additional plastic washer. Refer to
⇒ Fig. Release Bearing with Additional Plastic Washer , page 22
⇒ Fig. Only for Release Bearings with Additional Plastic Washer; Where the Pressure Plate Diaphragm
Springs -arrows- have a Slightly Lower Installation Height. , page 22
4 - Bolt
❑ M 6: 13 Nm
❑ M 7: 20 Nm
❑ Loosen and tighten in small steps and in diagonal sequence.
❑ Allocation. Refer to the Parts Catalog.
Golf 2015 ➤ , Golf Variant 2015 ➤
Manual Transmission - Edition 02.2016
, adapted pressure plate. Refer to
.
43
2. Clutch