Volkswagen Golf 2015 Repair Manual page 194

Golf 2015 ➤ , Golf Variant 2015 ➤
Manual Transmission - Edition 02.2016
– Install the outer race/tapered roller bearing with the selected
shim (in the example: 1.75 mm). Support transmission hous‐
ing directly beneath bearing mount using -2050- .
Checking Measurement
• The selected adjusting shim is installed.
– Position the measuring tools on the clutch housing and secure
them with a bolt -arrow-.
– Set the dial gauge (3 mm range) with 1 mm preload to 0 .
– Loosen securing bolts for clutch housing/transmission housing
in diagonal sequence until bolts clear transmission housing
and output shaft.
• For correctly selected adjustment shim, dial gauge must now
display a value of 0.15 mm to 0.25 mm.
Tightening Specifications
♦ Refer to
⇒ 5.3 Overview - Transmission Housing and Selector Mech‐
anism , page 111 .
2.3.2 Output Shaft, 5th, 6th and Reverse
Gears, Adjusting
Special tools and workshop equipment required
♦ Transmission Support - VW353-
♦ Dial Gauge Holder - VW387-
♦ Press Piece - Rod - VW407-
♦ Press Piece - Multiple Use - VW433-
♦ Seal Installer - Stator - VW792-
♦ Crankshaft Holding Fixture - VW801-
♦ Holding Plate - VW309A-
♦ Slide Hammer - Press Plate - 2050-
♦ Torque Wrench 1331 5-50Nm - VAG1331-
♦ Puller - Kukko Internal - 46-56mm - 21/07-
♦ Puller - Kukko Counterstay - 22/2-
♦ Dial Indicator - VAS6080A-
It is necessary to adjust the output shaft if the following compo‐
nents were replaced:
♦ Transmission Housing
♦ Clutch Housing
♦ Output shaft, 5th, 6th and Reverse Gears or
♦ Output shaft tapered roller bearing
Adjustment Overview. Refer to
⇒ 3 Adjustment Overview , page 221
190
Rep. Gr.35 - Gears, Shafts
.