Volkswagen Golf 2015 Repair Manual page 164

Golf 2015 ➤ , Golf Variant 2015 ➤
Manual Transmission - Edition 02.2016
Grooved Ball Bearing Installation Location and Installing the
Grooved Ball Bearing
• Grooved ball bearing installed position: The groove for the
locking ring faces up -arrow A- and the collar -arrow B- must
face the 5th gear wheel.
– Then select the grooved ball bearing locking ring and install it
on the input shaft. Refer to
⇒ Fig. Selecting the Locking Ring , page 160
Selecting the Locking Ring
– Insert a 1.86 mm locking ring -A- into groove in the input shaft
and press it upward.
– Measure the gap between the grooved ball bearing -B- and
the installed locking ring -A- with a feeler gauge -C-.
– Remove the locking ring used for the measurement.
– Select the locking ring according to the Table.
Note
For the correct locking rings. Refer to the Parts Catalog.
The following circlips are available:
Measured Value Circlip Ring Thick‐
(mm)
0.01 to 0.05
0.05 to 0.07
0.07 to 0.10
0.10 to 0.13
0.13 to 0.16
Removing the Cylindrical Roller Bearing from the Clutch Housing
– Compress the cylindrical roller bearing locking ring -arrow-
with pliers -C- and remove it.
A - Counter Support , for example, -22/2-
B - Internal Puller 30 to 37 mm , for example, -21/5-
160
Rep. Gr.35 - Gears, Shafts
Axial Play (mm)
ness (mm)
1.86 0.01 to 0.05
1.89 0.01 to 0.05
1.92 0.01 to 0.05
1.95 0.01 to 0.05
1.98 0.01 to 0.05
.