Volkswagen Golf 2015 Repair Manual page 196

Golf 2015 ➤ , Golf Variant 2015 ➤
Manual Transmission - Edition 02.2016
– Attach the measuring tools to the clutch housing.
In the case of protruding housing edges:
– Place washers (total thickness: 8 mm) under the -VW792-
-arrow-.
– Set the dial gauge (3 mm range) with 1 mm preload to 0 .
– Loosen securing bolts for clutch housing/transmission housing
in diagonal sequence until bolts clear transmission housing
and output shaft.
– Read measured value on dial indicator and note (example:
0.25 mm).
Note
The measured value will not be displayed when loosening the
♦
bolts that connect the clutch housing to the transmission hous‐
ing.
Install a 1.95 mm shim or, if necessary, a 2.20 mm shim in
♦
place of the 1.70 mm shim for measuring.
For the correct adjusting shim. Refer to the Parts Catalog.
♦
Determining the Shim
The required bearing tension is reached as follows:
The specified bearing pre-load is reached when determined
measured value (0.25 mm) is subtracted from inserted shim (1.70
mm).
A constant figure of (0.20 mm) is added to the reading.
Example
Inserted shim
- measured value
+ Preload (constant value)
= Shim thickness
– Select the correct shim thickness according to the table. Refer
to ⇒ page 193 .
192
Rep. Gr.35 - Gears, Shafts
1.70 mm
0.25mm
0.20 mm
1.65 mm