Volkswagen Golf 2015 Repair Manual page 130

Golf 2015 ➤ , Golf Variant 2015 ➤
Manual Transmission - Edition 02.2016
– Install the grooved ball bearing/input shaft locking ring -1-.
– Remove the -30-211A- for the input shaft.
– If the retaining sleeve for the shift lever shaft was removed,
then install it now all the way onto the tool. Refer to
⇒ Fig. Lock Sleeve Differentiation , page 136
– Turn the transmission so that the opening for the shift lever
shaft faces up in the assembly stand.
Note
Use the -80-200- to press against the spring force of the securing
bushing direction of -arrow- when installing so that the shift lever
shaft -1- does not touch the securing bushing -2- when removing.
– Install the shift lever shaft -1- into the lower bearing -2- and
into the shift forks -3-.
Note
The cover is not shown in the illustration. Refer to
⇒ 6.1 Overview - Transmission Housing , page 130
– Push the shift lever shaft -1- against the retaining sleeve -2-
in direction of -arrow- and guide is through the shift fork all the
way down using the shift finger -3-.
• The shift lever cover -4- must stand parallel to the bolting sur‐
face on the transmission housing.
• It must be possible to move the shift lever shaft easily (forward
and backward).
Note
If the gearshift cover is at an angle to the bolting surface, then the
gearshift shaft is not installed in the lower bearing.
126
Rep. Gr.34 - Controls, Housing
.
.