Volkswagen Golf 2015 Repair Manual page 100

Golf 2015 ➤ , Golf Variant 2015 ➤
Manual Transmission - Edition 02.2016
– Mount the cable bracket on the transmission and tighten the
bolts and nuts -arrows-. Refer to
⇒ 1.2 Overview - Selector Mechanism , page 60
– Install the selector cable in the cable retainer.
– Apply a small amount of grease on the pins -arrow- for the shift
lever -2-.
Grease allocation. Refer to the Parts Catalog.
– Replace the lock washer -1- each time it is removed.
– Adjust the shift lever mechanism. Refer to
⇒ 1.6 Selector Mechanism, Adjusting , page 71
– Install the starter. Refer to ⇒ Electrical Equipment; Rep. Gr.
27 ; Starter; Starter, Removing and Installing .
– Connect the front left connectors to the transmission:
1 - Transmission for vehicles with start/stop system: Transmis‐
sion Neutral Position Sensor - G701-
2 - Back-Up Lamp Switch - F4-
– Install the drive axles. Refer to ⇒ Suspension, Wheels, Steer‐
ing; Rep. Gr. 40 ; Drive Axle; Drive Axle, Removing and
Installing .
– Install the drive axle heat shield (if equipped). Refer to ⇒ Sus‐
pension, Wheels, Steering; Rep. Gr. 40 ; Drive Axle; Drive
Axle Heat Shield, Removing and Installing .
– Assemble the exhaust system. Refer to ⇒ Engine Mechanical,
Fuel Injection and Ignition; Rep. Gr. 26 ; Exhaust Pipes/Muf‐
flers; Overview - Muffler .
– Install the subframe together with pendulum support. Refer to
⇒ Engine Mechanical, Fuel Injection and Ignition; Rep. Gr.
10 ; Subframe Mount; Overview - Subframe Mount .
96
Rep. Gr.34 - Controls, Housing
.
.